configuration information with no manual intervention. of the Cisco Aironet AG Series allows the access point to be placed above ceilings in plenum. To clear or remove the manually entered controller information, you can use these EXEC. installed in accordance with Cisco’s installation instructions, it may cause interference with radio and television reception. This equipment has.

Author: Bakree Gadal
Country: Switzerland
Language: English (Spanish)
Genre: Life
Published (Last): 13 May 2013
Pages: 402
PDF File Size: 13.71 Mb
ePub File Size: 6.57 Mb
ISBN: 218-9-46786-664-6
Downloads: 95164
Price: Free* [*Free Regsitration Required]
Uploader: Fauran

The Summary Status page appears.


Page 47 Push down on the padlock to ensure the padlock is held by the security hasp adapter clips. Also, the access point no longer is assigned an IP address.

An Enter Network Step 2 Password screen appears. Page 96 — switches 1. Page 18 Preface Obtaining Additional Publications and Information Cisco Press publishes a wide range of general networking, training and certification titles.

Cisco Aironet 1130AG Hardware Installation Manual

The default password is Cisco. Page 72 Saves changes made on the page and remains on the page. Disconnect power from manuaal access point the power jack for external power or the Ethernet cable for in-line power. If any item is damaged or missing, notify your authorized Cisco sales representative. Table of Contents Add to my manuals Add. At the username and password prompts, enter your administrator username and password.


Step 4 Remove the key. Launch your browser, and go to this URL: Ciisco 35 2 to 32 characters.

IEEE Quadruple phase shift keying is a Page 50 – Connecting to an Ethernet Network with L Hvis du vil se oversettelser av de advarslene som finnes i denne publikasjonen, kan du se i vedlegget “Translated Safety Warnings” [Oversatte sikkerhetsadvarsler].

Aironet Extensions By default, the access point uses Cisco Aironet Page 39 If you do experience difficulty, the following sections provide basic troubleshooting information. Close the access point cover by sliding it over the security hasp adapter until you hear a click.

Manufacturers Federal Communication Commission Declaration Of Conformity Statement The Part 15 radio device operates on a non-interference basis with other devices operating at this Caution frequency when using the integrated antennas.

Note If you are connected to the access point using a Telnet session you lose your connection to the access point when you assign a new IP address to the BVI. Repeater non Access point connects to a remote LAN, accepts root associations from wireless clients, and must associate with a root access point using the wireless interface.

Ethernet and radio ports, the network uses the BVI. SSID table at the bottom of the page.


This device must accept any interference received, including interference that may cause undesired operation. The use of wireless devices in hazardous locations is limited to the constraints posed by the safety mwnual of such environments. For more details, contact Cisco Corporate Compliance.


The default Step 4 username is Cisco, and the default password is Cisco. Page – Statement Installation Instructions If you need to continue configuring the access point using Telnet, use the new IP address to open another Telnet session to the access point. Statement b-explosive Device Proximity Warning Varning! Aironet extensions must be enabled to support See the Cisco IOS software configuration guide for your switch.

Page 47 The Cisco warranty page appears. Page Page – Declarations of Conformity and Regulator Clear Clears the selected options on the page. The access point supports the IEEE Page IEEE Gently push the cover away from clsco until it stops, as shown in this illustration.

To move back to the beginning of the command entry, press Ctrl-B or the left arrow key repeatedly.